Mobile Concrete Block Making Machine-Mould
The mold is special tool for casting blanks. When the slurry from
the mixer cavity is purred into the injection mold, the cutting
blanks will come out after being fermented nursing, and the die
frame being removed.
The mold is composed of frame, side plate (base plate) and clamp
The frame is made of steel and it has good rigidity and it is
There is turning shaft in the both end, and it has seal to prevent
the casting leakage. The structure is very reasonable and it is
easy to turn.
Side plate (base plate)
The side plate is made of steel and welding plate. It has good
rigidity that it is hard to deform when being put into the
The clamp arm is composed of clamp wheel, arm and turning shaft,
the driving comes from the turnover hanger spanner device.
The mold should make the frame, side plate and clamp arm be
together, and then it can work, and it should have turnover hanger
when it works.
The frame is the main body of the mold, when the side plate is
assembled and tightened by the clamp arm, and turn up to 90°, it
can cast the blank. The hanger lift it in the sky and turn 90°
after the casting, the casting blank is lifted to the cutting
trolley vertically, loose the clamp arm, remove the frame, the
casting blank can be cut then.
The side plate is the plate used for opening the closed mold frame,
and then it will be clamped by the arm and be close to the frame
seal, then turn 90°, remove the mold on the cutting platform and it
will become the base plate for the casting blank.
The clamp arm is connected to the spanner of the turnover hanger,
the spanner turns 90° with the help of the cylinder, and it will
stop when the clamp action is done.
Calibration and adjustment:
Assemble the frame with the side plate, then the clamp arm can turn
After the side plate is tightly clamp, the mold turn 90°, there is
no leakage happen in the seal.
If clearance between the clamp arm and the side plate is very big
or it is hard to turn, adjust the assemble distance between the
clamp arm and the mold frame.
If the seal leakage happen, adjust the clamp arm press wheel.
Maintenance and repair:
Clean the slurry remain
Brush lubricant oil in the cavity after the mold frame assembled
with the side plate.
Replace the destroyed seal on time
The mold is installment already when it is ex-factory, it just need
to past the seal on-site, the seal adhesive is used neoprene ( 303
glue ) or 705 ( JX-5 ) anchor nitrile phenolic adhesive.
How to start a project?
We will offer the customized plant layout and the related design
documents. All the equipment will be debugged before the delivery.
We'll also arrange professional project manager and engineers for
site installation supervision and local training to ensure the
successful production start-up.