Automatic Concrete Block/Brick Making Machine for Construction with
ISO Approved-Casting mixer
The casting mixer is used for mixing concrete body before casting.
It is located on the casting blank mold.
1. Max outside size
Length:2520mm Width:2520mm Height:4113mm
5.Mixing type:Push type
7.Pneumatic butterfly valve:D67IJ-10-250
The casting mixer is composed of mixing drum and casting arm
The mixing drum is cylindrical and it is compose of motor, mixing
shaft and mixing blade
The sprue gate is controlled by the pneumatic butterfly valve.
The casting mixer adopts push-type method, which make the mixing
very quickly. It is driven by the motor, and the motor is rotated
as clockwise direction to drag the mixing blade to rotate, and make
the material turn in the drum
The casting arm is located under the mold. The butterfly valve
starts when the mixing material is acceptable, and the material
will goes into the casting arm and then start the casting.
Put the mixing drum on the prepared base, and the place the rubber
washer on the contact surface.
Trial running and adjus:
Adjust the parts below after the installment.
a.Tighten the motor belt.
b.Tighten the gasket screw
Adjust the casting arm base on process required and adjust the
The motor runs stably and rotate as clockwise direction.
The mixing drum is stable.
The shaft is easy to run, no abnormal sound.
The pneumatic butterfly valve well works
Adjust the distance between the draft tube and the caster base
(usually, the clearance is between 12cm and 18cm)
Maintenance and repair:
Clean the mixing drum, mixing shaft and casting arm once a week.
The gasket cover should be tight during the cleaning, and the each
bearing should be cleaned once per half year.
Disassemble the sprue gate and clean it and pneumatic butterfly
valve and the pipe once per month,
No one is allowed to stand on the top of the mixing drum or around
the casting arm.
Clean the flying material after each production shift.